![]() ![]() You may have to rotate one of the Conclusion Use your foot to press down on the bottom end cap while pulling down on both poles so that they are parallel to one another and taut against both walls. ![]() Carefully spread out each section of pole to its full length and place them inside your tub or shower stall at an angle so that they rest against opposite walls.Ĥ. Remove any sharp edges with a file or sandpaper before reassembling.ģ. Note: If your ceiling height is less than 8-foot-6 inches, adjust the height of the pole by twisting off the upper section of the pole and cutting it to size with a hacksaw. Rotate the feet until they lock into place. Place the adjustable feet on a flat surface inside the tub or shower. Rotate the pole until it locks into place.Ģ. Place the expanding end of the shower pole into the base. ![]() If they do not, check that all springs are tightened properly and shelves are lined up correctly. Insert screws through these holes and tighten them in place using screwdriver. Line up the holes in the sides of your caddy with the holes on your tension pole. Slide the top spring over top of pole and tighten it into place with a screwdriver. Attach the bottom spring to the bottom of pole and tighten it into place with a screwdriverĪttach top spring. It should slide under the lip of the unit. Place the bottom of the caddy onto the floor of your shower.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |